Mess- und Prüftechnik für
Industrie, Motorsport und Fahrzeugentwicklung

Info
Prices
Downloads
Sie sind hier: Products > AiM > Solo 2 > Solo 2 DL > Solo 2 DL plug&play > Solo 2 DL plug&play Yamaha > Solo 2 DL plug&play Yamaha R1 14

Solo 2 DL plug&play Yamaha R1 14

AiM Solo 2 DL Yamaha
AiM Solo 2 DL Yamaha
AiM Solo 2 DL Yamaha
AiM Solo 2 DL Yamaha
AiM Solo 2 DL Yamaha
AiM Solo 2 DL Yamaha
AiM Solo 2 DL Yamaha
AiM Solo 2 DL Yamaha
AiM Solo 2 DL Yamaha
AiM Solo 2 DL Yamaha

Solo 2 DL Plug & Play Kits for Yamaha R1 14

Our CAN Bus capable devices can now communicate with the Yamaha motorbikes of the models R1 2014. Using a special connection cable, we can tap the channels listed below via the engine control unit. Since no further steps are necessary for the customer other than plugging the model-specific cable into a plug that is standard in the vehicle and configuring the respective logger, we refer to these kits as plug & play.

In principle, however, our devices can be installed in any vehicle, even if there is no p&p version for it. If your model is not listed, please contact us and we will help you.

Supported models 

Yamaha YZF-R1 (YEC) 2009 - 2014


Channels over CAN-Bus

Engine Speed Water temperature
Speed Intake air temperature
Error message ECU

 Installation using the example Solo 2 DL

  • Connect the "Solo 2 DL connection cable for Yamaha"  to your Solo 2 DL via the 7-pin Binder 711 connector. It is the lower right input of your Solo 2 DL.

  •  Use the RaceStudio3 software to create a new configuration for your Solo 2 DL and select as ECU Manufacturer: YAMAHA and as ECU Model: BIKE_Rx.
     
  • Connect your Solo 2 DL to your PC via WLan.

  • Transfer the configuration to the AiM Solo 2 DL.

  • You can check the communication via the online mode.


Software Updates für AiM Produkte Firmware Updates für AiM Produkte AiM Produkte online kaufen

memotec GmbH | Bauwaldstrasse 1 | D-75031 Eppingen | +49.7260.920440 | info@me-mo-tec.de | www.me-mo-tec.de