Abmasse AiM SW4 280 Farbdisplay
The AiM
Steering Wheel 4 270mm is a steering wheel with a freely configurable 4.3" TFT display and integrated data recording. It has four configurable RGB alarm LEDs, eight configurable RGB switch lamps and two CAN connections for communication with over 2000 control units. In addition, it has ten freely configurable push-buttons and three rotary switches with RGB backlighting, the optional analogue inputs are expandable through Channel Expansion.
The sturdy aluminium housing meets the requirements of protection class IP65, making the Steering Wheel 4 suitable not only for touring cars but also for open vehicles. The integrated buttons can be used to adjust the settings of the Steering Wheel 4 and switch between the configured sides.
CAN-Bus Technology
Special features Steering Wheel 4 270mm
- opional configurable analogue inputs
- 8 RGB Shift lghts
- 4 RGB Alarm LED
- Lap times with up to 5 split times
- 10 push buttons with RGB backlight
- 3 Rotary switch with RGB backlight
- 4,3" TFT Display
- 4 GB storage
- 2 CAN interface
- ECU Interface
- Removable handle bars
- Optional shift and clutch paddles
Connection example AiM Steering Wheel 4 270mm
Technical Data AiM Steering Wheel 4 270mm
Rev counter |
Tapping from the control unit, terminal 1 of the ignition coil or CAN/OBDII Measuring range 0 to 22,000 rpm End of scale adjustable (x 1000): 4 - 6 - 7 - 8 - 10 - 12 - 14 - 15 - 16 - 18 - 20 - 22 Sampling rate 10 - 50 Hz, freely selectable Freely configurable over-revs control LED |
Time measurement |
Triggering via GPS Lap times without limit, up to 5 split times Measurement accuracy 1/100 sec. Lap time prediction |
Analogue channels |
Optionally expandable through Channel Expansion Optionally expandable through Thermocouple Hub 4 RGB Alarm-LED's if the set alarm values are exceeded or not reached Display in °C or °F Sampling rate 1 – 200 Hz, freely selectable |
Speed |
CAN and GPS acquisition 0 – 438, display in km/h or mph Sampling rate 10 - 50 Hz, depending on protocol |
Gear indication |
Calculated from rpm and speed |
Total sampling rate |
8950 Hz (without ECU) |
Connector |
1x Autosport 22 pin | Souriau 8STA61235SN | Deutsch AS61235PN 1x Mini USB on wiring harness |
Shift light |
8 freely configurable RGB LEDs Freely configurable for each gear |
Additional functions |
Display of the difference to the fastest lap in the split times Lap time prediction Light sensor for display illumination Calculated channels Freely configurable display |
Data storage |
Non-volatile 4 GB-Storage |
Data transfer |
USB |
Power supplys |
via 12V on-board power supply On / Off via ignition switch No data loss after switching off |
Updates |
Software and firmware updates free of charge via the Internet |
Measurements |
Housing: 270 x 183.5 x 42.6 mm Display: 95x 53.9 mm |
Weight |
2400 gr |
The functions of Steering Wheel 4 270mm
|
1 |
4 RGB Alarm LED, freely configurable |
2 |
8 RGB Shift lights, freely configurable |
3 |
gear indication |
4 |
Speed indication |
5 |
Analogue speed display , freely configurable |
6 |
Replaceable handle bars |
7 |
3 Rotary switch with RGB Backlighting |
8 |
10 Push button with RGB Backlighting |
9 |
Light sensor for lighting |
10 |
Optional shift paddles |
11 |
4,3" TFT Display |
|
|
The Display
The freely configurable 4.3" TFT colour display of the Steering Wheel 4 270mm has a contrast of 800:1 and a brightness of 800 cd/m2 or 1,100 lumens. A light sensor constantly adjusts the contrast and brightness to the environment. Whether different display pages, warning messages or mathematical channels - all this can be shown on the display.
Steering Wheel 4 270mm RGB Alarm- and shift lights
The AiM Steering Wheel 4 270mm has eight switching and eight alarm lamps. These are freely configurable in RGB colours.
The shift lamps can be set the same either for each gear or for all gears. A separate colour can be selected for each LED.
The eight alarm lamps can either light up, flash slowly or flash quickly when a set min. or max. value is reached. In addition, a message can be shown on the display or a signal can be emitted.
The alarm lamps can also be set in different RGB colours.
AiM RaceStudio3 Software for Steering Wheel 4 270mm
RaceStudio3 is the software for the new generation of AiM loggers.
This software can be used to create configurations and transfer them to the USB device. The measured values can be checked via an online mode or a recording can be started manually.
With RS3, mathematical channels can now also be created, transferred to the unit and shown on the display.
Expansions for SW4 270
Accessory for Steering Wheel4 270mm
|
|
|
|
|
|
|
Data Hub |
Temperature |
Movement |
Pressure |
Cable |
Connector |
|